IP Router Configuration Command Reference
208 Router Configuration Guide
Description This command creates the CLI context to configure interface level hold-up and hold-down timers for
the associated IP interface.
The up timer controls a delay for the associated IPv4 or IPv6 interface so that the system will delay
the deactivation of the associated interface for the specified amount of time.
The down timer controls a delay for the associated IPv4 or IPv6 interface so that the system will delay
the activation of the associated interface for the specified amount of time
up
Syntax up ip seconds
no up ip
up ipv6 seconds
no up ipv6
Context config>router>interface>hold-time
Config>service>ies>interface>hold-time
Config>service>ies>subscriber-interface>hold-time
Config>service>ies>redundant-interface>hold-time
Config>service>vprn>interface>hold-time
Config>service>vprn>network-interface>hold-time
Config>service>vprn>subscriber-interface>hold-time
Config>service>vprn>redundant-interface>hold-time
Config>service>vpls>interface>hold-time
Description This command will cause a delay in the deactivation of the associated IP interface by the specified
number of seconds. The delay is invoked whenever the system attempts to bring the associated IP
interface down.
The no form of the command removes the command from the active configuration and removes the
delay in deactivating the associated IP interface. If the configuration is removed during a delay period,
the currently running delay will continue until it expires.
Parameters seconds — The time delay, in seconds, to make the interface operational.
Values 1 to 1200
down
Syntax down ip seconds [init-only]
no up ip
up ipv6 seconds [init-only]
no up ipv6
Context config>router>interface>hold-time
Config>service>ies>interface>hold-time
Config>service>ies>subscriber-interface>hold-time
To Next Page
Loading...
