IP Router Configuration
Router Configuration Guide 229
Parameters milli-seconds — Specifies the length of time the router should be considered reachable.
Values 0 to 3600000
retransmit-time
Syntax retransmit-timer milli-seconds
no retransmit-timer
Context config>router>router-advert>if
Description This command configures the retransmission frequency of neighbor solicitation messages.
Default no retransmit-time
Parameters milli-seconds — Specifies how often the retransmission should occur.
Values 0 to 1800000
router-lifetime
Syntax router-lifetime seconds
no router-lifetime
Context config>router>router-advert>if
Description This command sets the router lifetime.
Default 1800
Parameters seconds — The length of time, in seconds, (relative to the time the packet is sent) that the prefix
is valid for route determination.
Values 0, 4 to 9000 seconds. 0 means that the router is not a default router
on this link.
use-virtual-mac
Syntax [no] use-virtual-mac
Context config>router>router-advert>if
Description This command enables sending router advertisement messages using the VRRP virtual MAC address,
provided that the virtual router is currently the master.
If the virtual router is not the master, no router advertisement messages are sent.
The no form of the command disables sending router advertisement messages.
To Next Page
Loading...
