IP Router Configuration
Router Configuration Guide 263
interface {ip-address | ip-int-name} statistics
interface dist-cpu-protection [detail]
interface policy-accounting [class [index]]
Context show>router
Description This command displays the router IP interface table sorted by interface index.
Parameters ip-address — Only displays the interface information associated with the specified IP address.
Values
ip-int-name — Only displays the interface information associated with the specified IP interface
name.
detail — Displays detailed IP interface information.
statistics — Displays packet statistics for an interface on the router.
summary — Displays summary IP interface information for the router.
exclude-services — Displays IP interface information, excluding IP interfaces configured for
customer services. Only core network IP interfaces are displayed.
family — Specifies the router IP interface family to display.
Values ipv4 — Displays only those peers that have the IPv4 family
enabled.
Values ipv6 — Displays the peers that are IPv6-capable.
Output Standard IP Interface Output — The following table describes the standard output fields for an IP
interface.
ipv4-address a.b.c.d (host bits must be 0)
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
Note: The show router interface statistics command also shows the MPLS statistics that
are shown in using the show router mpls interface statistics command. This allows the
operator to see MPLS statistics from interfaces that are not added to MPLS, such as a
carrier's network interfaces. Sample Output for an example of the MPLS fields that are
displayed. These fields are displayed regardless of the state of MPLS.
To Next Page
Loading...
