Show, Clear, and Debug Command Reference
308 Router Configuration Guide
Values The following values apply to the 7450 ESS:
ipv4-address: a.b.c.d (host bits must be 0)
tag tag — Displays the tag used to add a 32-bit integer tag to the static route. The tag is used in
route policies to control distribution of the route into other protocols.
Values 1 to 4294967295
Output Static Route Output — The following table describes the output fields for the static route table.
ipv4-address: a.b.c.d (host bits must be 0)
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
Table 27: Static Router Field Descriptions
Label Description
IP Addr/mask The static route destination address and mask.
Pref The route preference value for the static route.
Metric The route metric value for the static route.
Type BH
The static route is a black hole route. The nexthop for this type of route is
black-hole.
ID
The static route is an indirect route, where the nexthop for this type of route
is the non-directly connected next hop.
NH
The route is a static route with a directly connected next hop. The Nexthop
for this type of route is either the next hop IP address or an egress IP
interface name.
Next Hop The next hop for the static route destination.
Protocol The protocol through which the route was learned.
Interface The egress IP interface name for the static route.
n/a
indicates there is no current egress interface because the static route is
inactive or a black hole route.
To Next Page
Loading...
