Show, Clear, and Debug Command Reference
320 Router Configuration Guide
===============================================================================
Status Network Next Hop[Interface Name]
-------------------------------------------------------------------------------
Active 100.0.0.1/32 mda-2-1
Inactive 101.0.0.1/32 mda-2-1
Inactive 102.0.0.1/32 mda-2-1
Inactive 103.0.0.1/32 mda-2-1
Inactive 104.0.0.1/32 mda-2-1
Inactive 105.0.0.1/32 mda-2-1
Inactive 106.0.0.1/32 mda-2-1
Inactive 107.0.0.1/32 mda-2-1
Inactive 108.0.0.1/32 mda-2-1
Inactive 109.0.0.1/32 mda-2-1
-------------------------------------------------------------------------------
No. of Routes: 10
===============================================================================
*A:Dut-C# show router 1 tms routes
===============================================================================
TMS Routes (IPv4)
===============================================================================
Status Network Next Hop[Interface Name]
-------------------------------------------------------------------------------
Active 100.0.0.1/32 mda-2-1
-------------------------------------------------------------------------------
No. of Routes: 1
===============================================================================
tunnel-table
Syntax tunnel-table [ip-address[/mask]] [protocol protocol | sdp sdp-id] [summary]
Context show>router
Description This command displays tunnel table information. Auto-bind GRE tunnels are not displayed in show
command output. GRE tunnels are not the same as SDP tunnels that use the GRE encapsulation type.
When the auto-bind command is used when configuring a VPRN service, it means the MP-BGP NH
resolution is referring to the core routing instance for IP reachability. For a VPRN service this object
specifies the lookup to be used by the routing instance if no SDP to the destination exists.
Parameters ip-address[/mask] — Displays the specified tunnel table’s destination IP address and mask.
protocol protocol — Displays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output Tunnel Table Output — The following table describes tunnel table output fields.
To Next Page
Loading...
