VRRP
Router Configuration Guide 429
When explicit is specified, the priority-level value is used to override the base priority of the
virtual router instance if the priority event is set and no other explicit priority event is set with
a lower priority-level. The set explicit priority value with the lowest priority-level determines
the actual in-use protocol value for all virtual router instances associated with the policy.
Default delta
Values delta, explicit
weight-down
Syntax weight-down lag-ports-down-weight
no weight-down
Context config>vrrp>policy>priority-event>lag-port-down
Description This command creates a context to configure an event set threshold within a lag-port-down priority
control event. The weight-down command defines a sub-node within the lag-port-down event and is
uniquely identified with the lag-ports-down-weight parameter. Each weight-down node within the
same lag-port-down event node must have a unique lag-ports-down-weight value. Each weight-down
node has its own priority command that takes effect whenever that node represents the current
threshold. A single LAG can use either weight-threshold or port threshold. The command is required
for proper operation on mixed port-speed LAGs and can be used for non-mixed port-speed LAGs as
well.
The total number of sub-nodes (uniquely identified by the lag-ports-down-weight parameter) allowed
in the system is 2048.
A weight-down node is not required for each possible number of ports that could be down. The active
threshold is always the closest lower threshold.
The no form of the command deletes the event set threshold. The threshold may be removed at any
time. If the removed threshold is the current active threshold, the event set thresholds must be re-
evaluated after removal.
Default no weight-down
Parameters lag-ports-down-weight — The total weight of LAG ports down to create a set event threshold.
This is the active threshold when the weight of down ports in the LAG equals or exceeds lag-
ports-down-weight, but does not equal or exceed the next highest configured lag-ports-down-
weight.
Values 1 to 64
mc-ipsec-non-forwarding
Syntax [no] mc-ipsec-non-forwarding tunnel-grp-id
Context config>vrrp>policy>priority-event
To Next Page
Loading...
