Show, Monitor, Clear, and Debug Command Reference
458 Router Configuration Guide
Priority Effect Delta
A delta priority event is a conditional event defined in a priority control
policy that subtracts a given amount from the base priority to give the
current in-use priority for the VRRP virtual router instances to which
the policy is applied.
Explicit
A conditional event defined in a priority control policy that explicitly
defines the in-use priority for the VRRP virtual router instances to
which the policy is applied.
Explicit events override all delta events. When multiple explicit events
occur simultaneously, the event with the lowest priority value defines
the in-use priority.
Current Priority The configured delta-in-use-limit priority for a VRRP priority control
policy or the configured delta or explicit priority for a priority control
event.
Event Oper State The operational state of the event.
Hold Set Remaining The amount of time that must pass before the set state for a VRRP
priority control event can transition to the cleared state to dampen
flapping events.
Priority The base priority used by the virtual router instance.
Priority Effect Delta
The priority-level value is subtracted from the associated virtual router
instance’s base priority when the event is set and no explicit events are
set. The sum of the priority event priority-level values on all set delta
priority events are subtracted from the virtual router base priority to
derive the virtual router instance in-use priority value.
If the delta priority event is cleared, the priority-level is no longer used
in the in-use priority calculation.
Explicit
The priority-level value is used to override the base priority of the
virtual router instance if the priority event is set and no other explicit
priority event is set with a lower priority-level.
The set explicit priority value with the lowest priority-level determines
the actual in-use protocol value for all virtual router instances
associated with the policy.
Hold Set Config The configured number of seconds that the hold set timer waits after an
event enters a set state or enters a higher threshold set state, depending
on the event type.
Table 41: VRRP Policy Event Output Fields Descriptions (Continued)
Label Description
To Next Page
Loading...
