Filter Configuration Command Reference
542 Router Configuration Guide
A packet matching the entry will be dropped.
• drop hop-limit
A packet matching the entry will be dropped only if the “Hop Limit” field in the packet’s IPv6
header matches the configured condition.
• drop payload-length
drop payload-length – A packet matching the entry will be dropped only if the “Payload
Length” field in the packet’s IPv6 header matches the configured condition.
• forward
A packet matching the entry will be forwarded using regular routing.
• forward esi
forward esi service-id – A packet matching the entry will be forwarded to the ESI identified
as the first appliance in the Nuage service chain using an EVPN-resolved VXLAN tunnel in
the specified VPLS service.
• forward esi
forward esi sf-ip vas-interface router — A packet matching the entry will be forwarded to
ESI/SF-IP identified as the first appliance in Nuage service chain using EVPN-resolved
VXLAN tunnel over the configured VAS interface in the specified VPRN service.
• forward next-hop
forward next-hop – A packet matching the entry will be forwarded in the routing context of
the incoming interface using a direct or indirect IP address in the routing lookup.
• forward lsp
forward lsp – A packet matching the entry will be forwarded using the specified LSP.
• forward next-hop
forward next-hop router – A packet matching the entry will be forwarded in the configured
routing context using a direct or indirect IP address in the routing lookup.
• forward redirect-policy
forward redirect-policy – A packet matching the entry will be forwarded using forward
next-hop or forward next-hop router and the IP address of the destination selected by the
configured redirect policy. If no destination is selected, packets are subject to action
forward.
• forward router
forward router – A packet matching the entry will be routed in the configured routing
instance and not in the incoming interface routing instance.
• forward sap
forward sap – A packet matching the entry will be forwarded using the configured SAP.
• forward sdp
forward sdp – A packet matching the entry will be forwarded using the configured SDP.
• http-redirect
http-redirect – An HTTP GET packet matching an entry is forwarded to the CPM for HTTP
captive portal processing. When allow-radius-override is configured, the system overwrites
the configured redirect-url-string with the URL returned from RADIUS.
• nat
To Next Page
Loading...
