Filter Configuration Command Reference
576 Router Configuration Guide
interval
Syntax interval seconds
no interval
Context config>filter>redirect-policy>dest>ping-test
config>filter>redirect-policy>dest>snmp-test
config>filter>redirect-policy>dest>url-test
Description This command specifies the amount of time, in seconds, between consecutive requests sent to the far
end host.
Default 1
Parameters seconds — Specifies the amount of time, in seconds, between consecutive requests sent to the far
end host.
Values 1 to 60
timeout
Syntax timeout seconds
no timeout
Context config>filter>redirect-policy>dest>ping-test
config>filter>redirect-policy>dest>snmp-test
config>filter>redirect-policy>dest>url-test
Description Specifies the amount of time, in seconds, that is allowed for receiving a response from the far-end host.
If a reply is not received within this time the far-end host is considered unresponsive.
Default 1
Parameters seconds — Specifies the amount of time, in seconds, that is allowed for receiving a response from
the far end host.
Values 1 to 60
priority
Syntax priority priority
no priority
Context config>filter>redirect-policy>dest
Description Redirect policies can contain multiple destinations. Each destination is assigned an initial or base
priority which describes its relative importance within the policy.
Default 100
To Next Page
Loading...
