Show, Clear, Monitor, and Debug Command Reference
604 Router Configuration Guide
counters — Displays counter information for the specified filter ID. Egress counters count the
packets without Layer 2 encapsulation. Ingress counters count the packets with Layer 2
encapsulation.
type entry-type — Specifies type of filter entry to display:
Values fixed, radius-insert, credit-control-insert, flow-spec, embedded,
radius-shared, pcc rule (applies only to the 7750 SR)
embedded [inactive] — Shows all embeddings, optionally shows inactive embedding only, if ip-
filter-id is not specified shows all embedded filters.
Output Show Filter (no filter-id specified) — The following table describes the command output for the
command when no filter ID is specified.
Sample Output
A:ALA-49# show filter ip
===============================================================================
Configured IP Filters Total: 2
Table 50: Filter IP Output Field Descriptions
Label Description
Filter Id The IP filter ID
Scope Template
The filter policy is of type template.
Exclusive
The filter policy is of type exclusive.
Applied No
The filter policy ID has not been applied.
Yes
The filter policy ID is applied.
Description The IP filter policy description.
In Shows embedding filter index
From Shows embedded filters included
Priority Shows priority of embedded filter
Inserted Shows embedded/total number of entries from embedded filter
Status:
OK—embedding operation successful, if any entries are overwritten
this will also be indicated.
Failed—embedding failed, the reason is displayed (out of resources).
To Next Page
Loading...
