Show, Clear, Monitor, and Debug Command Reference
624 Router Configuration Guide
Service Id The service ID on which the filter policy ID is applied.
SAP The Service Access Point on which the filter policy ID is applied.
(Ingress) The filter policy ID is applied as an ingress filter policy on the interface.
(Egress) The filter policy ID is applied as an egress filter policy on the interface.
Type The type of service of the service ID.
Entry The filter ID filter entry ID. If the filter entry ID indicates the entry is
Inactive, the filter entry is incomplete, no action was specified.
Log Id The filter log ID.
Src. IP The source IP address and mask match criterion. 0.0.0.0/0 indicates no
criterion specified for the filter entry.
Dest. IP The destination IP address and mask match criterion. 0.0.0.0/0 indicates
no criterion specified for the filter entry.
Protocol The protocol ID for the match criteria. Undefined indicates no protocol
specified.
ICMP Type The ICMP type match criterion. Undefined indicates no ICMP type
specified.
Fragment False
Configures a match on all non-fragmented IP packets.
True
Configures a match on all fragmented IP packets.
Off
Fragments are not a matching criteria. All fragments and nonfragments
implicitly match.
Sampling Off
Specifies that traffic sampling is disabled.
On
Specifies that traffic matching the associated IP filter entry is sampled.
IP-Option Specifies matching packets with a specific IP option or a range of IP
options in the IP header for IP filter match criteria.
Table 56: Filter IPv6 Associations Output Field Descriptions (Continued)
Label Description
To Next Page
Loading...
