Show, Clear, Monitor, and Debug Command Reference
630 Router Configuration Guide
If the packet being logged does not have a source or destination MAC address (i.e., POS) then the
MAC information output line is omitted from the log entry.
In case log summary is active, the filter log mini-tables contain the following information..
Sample Output
2007/04/13 16:23:09 Filter: 100:100 Desc: Entry-100
Interface: to-ser1 Action: Forward
Total Log Instances
(Allowed)
Specifies the maximum allowed instances of filter logs allowed on the
system.
Total Log Instances (In
Use)
Specifies the instances of filter logs presently existing on the system.
Total Log Bindings Specifies the count of the filter log bindings presently existing on the
system.
Type The type of service of the service ID.
Filter ID Uniquely identifies an IP filter as configured on the system.
Entry ID The identifier which uniquely identifies an entry in a filter table.
Log Specifies an entry in the filter log table.
Instantiated Specifies if the filter log for this filter entry has or has not been
instantiated.
Table 59: Filter Log Summary Minitable Field Descriptions
Label Description
Summary Log LogID Displays the log ID.
Crit1 Summary criterion that is used as index into the mini-tables of the log.
TotCnt The total count of logs.
ArpCnt Displays the total number of ARP messages logged for this log ID.
Src...
Dst...
The address type indication of the key in the mini-table.
count The number of messages logged with the specified source/destination
address.
address The address for which count messages where received.
Table 58: Filter Log Output Field Descriptions (Continued)
Label Description
To Next Page
Loading...
