Show, Clear, Monitor, and Debug Command Reference
638 Router Configuration Guide
Output Redirect Policy Output — The following table describes the fields in the redirect policy command
output.
Table 64: Filter Redirect-Policy Output Field Descriptions
Label Description
Redirect Policy Specifies a specific redirect policy.
Applied Specifies whether the redirect policy is applied to a filter policy entry.
Description Displays the user-provided description for this redirect policy.
Active Destination ip address
Specifies the IP address of the active destination.
none
Indicates that there is currently no active destination.
Destination Specifies the destination IP address.
Oper Priority Specifies the operational value of the priority for this destination. The
highest operational priority across multiple destinations is used as the
preferred destination.
Admin Priority Specifies the configured base priority for the destination.
Admin State Specifies the configured state of the destination.
Out of Service
Tests for this destination will not be conducted.
Oper State Specifies the operational state of the destination.
Ping Test Specifies the name of the ping test.
Timeout Specifies the amount of time in seconds that is allowed for receiving a
response from the far-end host. If a reply is not received within this time
the far-end host is considered unresponsive.
Interval Specifies the amount of time in seconds between consecutive requests
sent to the far end host.
Drop Count Specifies the number of consecutive requests that must fail for the
destination to declared unreachable.
Hold Down Specifies the amount of time in seconds that the system should be held
down if any of the test has marked it unreachable.
Hold Remain Specifies the amount of time in seconds that the system will remain in
a hold down state before being used again.
Last Action at Displays a time stamp of when this test received a response for a probe
that was sent out.
To Next Page
Loading...
