Cflowd
Router Configuration Guide 739
shutdown
Syntax [no] shutdown
Context config>cflowd
config>cflowd>collector
Description This command administratively disables an entity. When disabled, an entity does not change, reset, or
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of this command administratively enables an entity.
Unlike other commands and parameters where the default state is not indicated in the configuration
file. The shutdown and no shutdown states are always indicated in system generated configuration
files.
template-set
Syntax template-set {basic | mpls-ip | l2-ip}
Context config>cflowd>collector
Description This command specifies the set of templates sent to the collector when using cflowd Version 9 or
Version 10.
Default basic
Parameters basic — Basic flow data is sent.
mpls-ip — Extended flow data is sent that includes IP and MPLS flow information.
l2-ip — Extended flow data is sent that includes Layer 2 (Ethernet) and IP flow information.This
template is only applicable for v10(IPFIX) collectors.
export-mode
Syntax export-type [automatic | manual]
Context config>cflowd
Description This command can be used to control how exports are generated by the cflowd process. The default
behavior is for flow data to be exported automatically based on the active and inactive time-out values.
The alternative mode is manual in which case flow data is only exported when the command “tools
perform cflowd manual-export” is issued. The only exception is if the cflowd cache overflows, in
which case the normal automatic export process is used.
Default export-mode automatic
To Next Page
Loading...
