144 Rockwell Automation Publication 750-IN001P-EN-P - April 2017
Chapter 3 Lift and Mount the Drive
Figure 93 - Reach Position B
Remove Drive Assembly or
Cabinet Options Assembly
This section assumes that the steps in Release Drive Assembly from Cabinet or
Release Cabinet Options Assembly from Cabinet
and Prepare the Roll-out
Cart have been completed.
ATTENTION: A tip-over hazard exists. To guard against death, serious
personal injury, and/or equipment damage, verify the drive stop (see Figure
91) is in the same position as the corresponding threaded leveling studs. The
weight of the drive must be evenly distributed over the cart wheels.
142
(5.6)
To Next Page
Loading...
