Allen-Bradley 20F - Removal and Storage; Wall Mount Frames 1, 6, and 7 Power Jumper; Wire Removal and Storage

Rockwell Automation Publication 750-IN001P-EN-P - April 2017 219
Power Wiring Chapter 4
Wall Mount Frames 1, 6, and 7 Power Jumper Wire Removal and
Storage
Wall/Flange Mount Frames 1, 6, and 7 use jumper wires to complete an
electrical connection when installed. Install or remove jumper wires according
to the recommendations in Table 45
.
Figure 123 - Wall Mount Frame 1 Jumper Wire Locations
When jumper wires are connected, the spade connector should be pressed
firmly onto the sheet metal tab.
ATTENTION: Hazard of equipment damage exists if jumpers are not properly
disconnected. For Frames 1, 6, and 7, secure the disconnected jumper wire to
the insulated position provided.
PE-A
PE-B
Disconnected
Connected
Disconnected
Connected