Rockwell Automation Publication 1789-UM002K-EN-P - January 2015 161
Appendix A
Communicate with Devices on a
DeviceNet Network
This chapter explains how to configure your SoftLogix controller on a DeviceNet
network.
The DeviceNet network is an open standard network used for device layer
networking and is responsible for these parameters:
• Node number
• Tra n s mi t si ze
• Receive size
• Message type
• Input data address
• Output data
For additional information about communicating with DeviceNet devices,
see the DeviceNet Network Configuration User Manual,
publication DNET-UM004
.
Topic Page
Configure Your System for a DeviceNet Network 162
Perform DeviceNet Test 181
DeviceNet I/O Data 188
Place the Communication Card in Run Mode 190
StatusRegister 191
Example: SoftLogix Controller and DeviceNet I/O 193
DeviceNet modules are not currently supported in RSLogix 5000 software on
64-bit Windows operating systems.
DeviceNet is supported in SoftLogix software, version 20 or earlier.
DeviceNet is not supported for SoftLogix controllers in the Studio 5000
environment.
To Next Page
Loading...
