Amada WELD CHECKER MM-400A - Page 128

MM-400A
8. Operation Screens
8-88
(4) PULSE 2 RESET
Select OFF or ON.
Available only when REFERENCE is set for MEASUREMENT MODE. For the
measurement mode, refer to Chapter 8, “m-3. EXTEND SETUP (3) Screen.”
A: A zero rest of displacement is performed after the elapse of RESET DELAY
TIME following the end of WE1.
B: Reset delay time C: Measurement of “DIST PULSE2”
D: Measurement of “DIST FINAL” E: Pulse delay time 2
F: Final delay time
(5) Function keys
MENU: Touching this displays the MENU screen.
NEXT: Touching this displays the EXTEND SETUP (3): DISPLACEMENT (3/3)
screen.
PREV: Touching this displays the EXTEND SETUP (1): DISPLACEMENT (1/3)
screen.
DIST: Touching this displays the EXTEND SETUP (3): DISPLACEMENT (3/3)
screen.
FORCE: Touching this displays the EXTEND SETUP (4): FORCE (1/2)
screen.
EXTERNAL: Touching this displays the EXTEND SETUP (6): EXTERNAL
(1/2) screen.
m-3. EXTEND SETUP (3) Screen: DISPLACEMENT (3/3)
(7)
(6)
(5)
(3)
(4)
(2)
(1)
WE
1 CO1 WE2 CO2 WE3
0
+(-)
-(+)
B
A C
F
D
E
Displacement
Welding current
Judgment output
Head UP