7. To create a new product,
select .
8. Enter the name for the product under "Product
name".
9. Enter the units for the product under "Units".
10. Confirm with
.
11. To assign a product,
select the desired products under "Products".
The selected products are marked with a
checkmark.
12. Confirm with .
The selected products are assigned to the job and
the setpoint receiver of the implement.
13. To change the setpoint for the products,
Select the desired product under "Products".
14. Enter the setpoint.
15. Confirm with
.
P | Working with documentation | Managing products
MG6010-EN-GB | G.1 | 13.12.2018
69
To Next Page
Loading...
