EasyManuals Logo

Analog way LivePremier Series User Manual

Analog way LivePremier Series
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
www.analogway.com
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
Mobile version
Prerequisite: to access the LivePremier with a mobile device, a wi-fi router must be connected on the same network as the
LivePremier unit.
A lighter version WebRCS is also available on iOS and Android mobile devices without any installation needed.
To access the WebRCS from a mobile device, launch a web browser and enter the LivePremier IP address in
the address bar.
This mobile version is simplified and has less features (no Preconfig or setup):
- Check rear panel connection status
- Check input video signals
- Load Screen memories and Multiviewer memories
- Trigger transitions
Tip: For an optimized interface, do not display the mobile browser in Desktop mode.
Section buttons (copy, paste and reset)
On multiple pages of the WebRCS, the following buttons appear:
: Copy the settings
: Paste copied settings
: Reset the settings
These buttons are associated to a specific section. Use these buttons to quickly copy, paste or reset the
settings of one section. Paste works when similar settings are currently copied (i.e. layer position copied to a
different layer in a different screen).
Set a number value
In the WebRCS, the fields for number values can be set and adjusted in different ways:
- Click and enter a number value
- Click the field and hold then move the mouse left or right
- Click and use the scroll wheel for small adjustments (mouse must remain in the field)
- Click the Up and Down arrows at the end of the field for single unit adjustment
Search bar
In the top bar, use the search bar to simply access a feature or setting.
1. Click the search bar.
2. Enter a keyword to search (ex: Input, Pattern, Keying).
The search results are displayed.
3. Click a result to open the corresponding page.
Alarms and notifications
In the top bar, alarms and notifications display when the following events occur:
- A component is missing or not detected
- A component is not compatible with the current firmware version
- A high temperature has been measured (card, fan, or device alarm)
- Pending changes are waiting to be applied
Open the history log to check history of alarms and notifications.
It is possible to mark notifications as read or clear them all.

Table of Contents

Other manuals for Analog way LivePremier Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Analog way LivePremier Series and is the answer not in the manual?

Analog way LivePremier Series Specifications

General IconGeneral
BrandAnalog way
ModelLivePremier Series
CategoryProjector Accessories
LanguageEnglish

Related product manuals