USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
Input Aspect
In Inputs, select an input. In Aspect, set the Aspect ratio or set input crop.
Note: Aspect ratio and Crop replaces the input content and affects every layer using it. If needed, use crop at layer level in Live or duplicate
the input with a splitter.
10.2.4.1 Set input aspect ratio
Change the input aspect ratio in all layers. Use these settings to correct the input aspect ratio if needed.
Note: Change aspect ratio at layer level to keep the input unchanged.
Description / Setting selection
Force an aspect ratio for the input if it needs correction (non-square pixels)
(Native; 5:4; 4:3; 16:10; 15:9; 16:9; 21:9 or 64:27)
Set the final aspect ratio for the input. This will be the native aspect ratio in the layer.
(Native; 5:4; 4:3; 16:10; 15:9; 16:9; 21:9 or 64:27)
1:1; Centered; Fullscreen or Cropped
10.2.4.2 Set input crop
Crop input (ex: black bars) and keep only wanted area in layers.
Description / Setting selection
On/Off toggle. Display cropping area in output, use during setup and disable Finder
to show the crop result output.
Enter cropping values (in pixels)