Analog way LivePremier Series - 8 Multiviewers; Multiviewers Settings; Multiviewers Signal

50
www.analogway.com
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
8 Multiviewers
A Multiviewer is an output displaying a user customizable selection of Widgets as display resources. A Widget
is a Multiviewer layer containing a program, preview, input or image. One Multiviewer can display up to 24
Widgets.
In Multiviewers, set the Label, Signal parameters, Patterns and Image correction.
Note:
- Go to Preconfig > Multiviewers to enable One Multiviewer or Two Multiviewers screens.
- Go to Multiviewers to set the Multiviewers layout and Widgets.
8.1 Multiviewers settings
In Multiviewers, click a Multiviewer output to open its settings. The selected output is highlighted in the
interactive rear panel.
- On the interactive rear panel, hover on an output connector to display information about this output.
- On the interactive rear panel, click an output to open its settings.
8.2 Multiviewers signal
In Multiviewers, select one Multiviewer. In Signal, the following settings are displayed:
Setting name
Description / Setting selection
Label
Rename the Multiviewer
Mode
Set to follow internal rate or select a custom rate in the list
Format
Set the format for the Multiviewer display
Color Space
Auto or RGB (Full or Limited), YCbCr (4:4:4, 4:2:2 or 4:2:0) and ITU-R BT. (709 or
2020)
Color Depth
8 bits, 10 bits or 12 bits
DVI mode
Enable to change DisplayPort signal into DVI signal if using a DVI connector on the
Multiviewer display.
HDCP
Disable*; Auto; HDCP 1.x; HDCP 2.x Type 0 or HDCP 2.x Type 1.
*Disabling HDCP reduces possible problems when the content is not fully HDCP compliant. When output HDCP is disabled, HDCP-
protected inputs are not displayed.
Recommendation: Always use high quality cables to prevent connection and bandwidth errors when using HDCP.