Anritsu MS9710C - Page 253

Appendix
A-4
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
260
261
No.
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
Status
Invalid In Zero Span
Invalid In Auto PMD
Invalid In Analysis
Invalid In Swp-Avg
Set A Trace or B Trace
Invalid In A-B,B-A Trace
Invalid In A-B Trace
Invalid In B-A Trace
Invalid In A&B Trace
Invalid In Multi Peak
Invalid In Opt. Amp-Test
Invalid In Smplg-5001 pnt
Invalid In Plzn Null, Pulse, WDM
Invalid In This State
Set Same Wl For A,B
Set Same Resolution For A,B
Set Same Points For A,B
Set Same Air/Vac For A,B
Option Error
Invalid In TLS Tracking
Invalid In Frequency Marker
Error message
Invalid when zone markers are displayed.
Invalid in the auto mode (PMD).
Invalid in the analysis mode.
Invalid in the sweep average mode.
Invalid when the trace mode is not A or B.
Invalid when the trace mode is A-B or B-A.
Invalid when the trace mode is A-B.
Invalid when the trace mode is B-A.
Invalid when the trace mode is A&B.
Invalid during multipeak detection.
Invalid during optical amp. test.
Invalid when the number of sampling
points is 5001.
Invalid when in the PLzn-Null, Pulse,
or WDM test mode.
Invalid under this measurement condition.
Difference in wavelength between
memories A and B.
Difference in resolution between
memories A and B.
Difference in number of points
between memories A and B.
Difference in Air/Vac mode between
memories A and B.
Option error
Invalid in TLS Tracking.
Invalid when the marker mode is
frequency.
Output condition