Anritsu MS9710C - Page 53

Section 4 Initial Setting
4-14.
■ Items not changes at power-on
(1) Address
(2) Associated calibration data
(3) Data and states that change with the responses to the following common
query commands
∗IDN? (
Section 7)
∗OPT? (
Section 7)
∗PSC? (Not supported by the MS9710C)
∗PUD? (Not supported by the MS9710C)
∗RDT? (Not supported by the MS9710C)
■ Items related to power-on status clear (PSC) flag
When the PSC flag is false, the service request enable register ( Sec-
tion 8.3), standard event status enable register (
Section 8.4), and paral-
lel poll enable register are not affected.
When the PSC flag is true or the ∗PSC command has not been executed, the
above registers are not cleared.
( The PSC command is not supported by the MS9710C)
■ Items that change at power-on
(1) Current device function test
(2) Status information
(3) ∗SAV/∗RCLregister (Not supported by the MS9710C)
(4) Macro definition made with a ∗DDT command
(Not supported by the MS9710C)
(5) Macro definition made with a ∗DMC command
(Not supported by the MS9710C)
(6) Macro definition made with an ∗EMC command
(Not supported by the MS9710C)
(7) Address received with a ∗PCB command (Not supported by the MS9710C)