5-3 Battery Information Battery Information and Replacement
5-2 PN: 10580-00307 Rev. D MS20xxC MM
Recharging
• The battery pack that is supplied with the MS202xC or MS203xC VNA Master may need charging before
you use it.
• Before using the VNA Master, the internal battery may be charged either in the VNA Master, by using
the AC Power Adapter, or in an automobile by using the Automotive 12 Volt DC Adapter.
• The battery can also be charged separately in the optional Dual Battery Charger.
• Recharge the battery only in the VNA Master or in an Anritsu-approved charger.
• Do not charge batteries for longer than 24 hours. Overcharging may shorten battery life.
Analyzer Not In Use
• When the VNA Master or the charger is not in use, disconnect it from the power source.
• A fully charged battery will discharge itself over time if left unused.
• Temperature extremes affect the ability of the battery to charge. Allow the battery to cool down or warm
up, as necessary, before use or charging.
• Discharge the battery from time to time to improve battery performance and battery life.
• Storing the battery in extremely hot or extremely cold places will reduce the capacity and lifetime of the
battery.
Physical Handling of Batteries
• Never short-circuit the battery terminals.
• Do not drop, mutilate, or attempt to disassemble the battery.
Battery Disposal
• The battery can be charged and discharged hundreds of times, but it will eventually wear out.
• Batteries must be recycled or disposed of properly. Do not place batteries in household garbage.
Warning Do not dispose of batteries in a fire!
To Next Page
Loading...
Need help?
General
