EasyManua.ls Logo

Arbiter Systems 1084A - Page 19

Arbiter Systems 1084A
256 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
List of Tables
2.1 Annunciator LED Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
2.2 Command Key Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
3.1 Available IEC-320 Cordsets by Country . . . . . . . . . . . . . . . . . . . . . . . . . 12
3.2 Fuse Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
4.1 Antenna Mounting Bracket Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . 18
4.2 GPS Cable Data and Accessory Information . . . . . . . . . . . . . . . . . . . . . . . 22
5.1 Output Signal Selection Jumper Settings . . . . . . . . . . . . . . . . . . . . . . . . . 25
5.2 JMP1, Event Input Jumper Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
5.3 Fiber Optic Output, JMP2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
5.4 FAULT Relay Output Control, JMP4 . . . . . . . . . . . . . . . . . . . . . . . . . . 28
6.1 Front-Panel Setup Menus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
6.2 Default Firmware Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
7.1 Drive Current vs. Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52
7.2 IRIG-B Time Code Types Available . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
7.3 Programmable Pulse Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
9.1 Fault Indications and Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 66
9.2 Survey-Position Hold Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73
9.3 System Status Information Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
9.4 Unlocked Time Quality . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
9.5 Auto Survey Setup Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80
9.6 Option Control Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85
9.7 Main RS-232C Port Pin Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86
10.1 Fault Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90
A.1 Setup Functions Listed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98
A.2 Main RS-232 Port Pin Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99
A.3 Temperature and Humidity List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100
C.1 Output Connector Jumper Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111
C.2 Option 06, Connector Pin Designation . . . . . . . . . . . . . . . . . . . . . . . . . . 118
C.3 Option 17, Connector Pin Designation . . . . . . . . . . . . . . . . . . . . . . . . . . 132

Table of Contents