Room Devices
Telligence
42PM000224A / 10 August 2022 / Ver. H
Button LEDs
A steady, bright button LED indicates that a nurse call alarm has been activate by:
• A patient pressing the call button on a handset, pillow speaker, call cord, or bed button
• A staff member pressing a Bedside module button or a button on a staff device in the
patient room
• Auxiliary equipment connected to an auxiliary input device
• A steady, dim LED indicates that the station is powered and ready to be activated. It is
used for easy location at nighttime.
SafeConnect Socket LEDs
• A steady LED indicates that a SafeConnect plug is connected.
• Depending on the handset model or call cord that you connect to a Patient Station's
SafeConnect socket, the LED above the socket will blink bright green or white for a few
seconds, and then dim to a steady green to indicate the handset is properly connected.
• The SafeConnect socket LED blinks when the plug is disconnected or an unsupported
device has been connected.
Tone and Buzzer Alerts
Room modules and dome lights emit tones; supervisory dome lights emit buzzes. Each tone or
buzzer pattern is associated with a specific event type and is configured during system
installation. Contact your system administrator for a list of tone and buzzer patterns and their
meanings.
• Call Assurance: The call assurance tone indicates a call was generated.
• Pre-Alert: The module beeps once when an audio connection is established.
• Staff Follow: When a staff member registers presence in a patient room, the device emits
staff follow tones.
• Staff Follow tones sound a short or continuous tone based on configuration.
• The Staff Follow tone pattern sounds the highest priority call in the duty area.
• The Speech module can be configured for continuous toning (duty tones) for use in staff
locations to indicate active events.
Cancel a Nurse Call Alarm from a Module
You can cancel a call by pressing the module’s Cancel or Reset button, or by registering staff
presence in the room. Which button you press will depend on how your system was configured
during installation. Contact your system administrator if you are uncertain how to cancel calls in
your system.
Register Staff Presence
Telligence supports manual and automatic staff presence registration. Both are optional. Staff
presence tracking shows the locations of staff as they move about the facility. Presence is
registered by room and by staff level.
Telligence supports three staff levels:
• Red: High staff level
• Amber: Medium staff level
• Green: Low staff level
To Next Page
Loading...