Dome Lights
Telligence
66PM000224A / 10 August 2022 / Ver. H
Dome Lights
This chapter describes the types of dome lights that are available in the Telligence System.
Figure 68: Dome Light Signaling Sections
Overview of Dome Lights
Telligence dome lights provide visual and audio cues to the type and source of active nurse
calls. Dome lights are typically located in facility hallways where they can be seen by staff.
Dome light colors and flash rates identify the various nurse call types and priorities. Depending
on your system’s configuration, each dome light section can display nine possible colors: blue,
red, white, amber, green, pink, cyan, magenta, and yellow. Dome light section colors indicate
nurse call types and priorities, as well as a staff member’s registered presence level and any
services tasks assigned to a room or bed.
Dome lights also can be used for supervisory purposes and provide both visual and audible
cues that indicate a staff console or annunciator has experienced a power and/or data
interruption.
Note: The term “dome light,” as used in this manual, generically identifies corridor lights, zone
lights, and nurse station supervisory lights.
Dome Light Types
Telligence dome lights have two or four light sections. The lights can be used as corridor, zone,
or supervisory lights.
Corridor Lights
Corridor lights signal nurse calls and priorities. They are mounted outside toilet rooms, patient
rooms, or staff rooms. Corridor lights indicate conditions inside the rooms.
Two light models:
• Section 1 - high priority nurse call events
• Section 4 - registered presence or a service task
Four light models:
• Section 1 - highest priority nurse all events
Section 1
Section 2
Section 3
Section 4
To Next Page
Loading...