Cleaning and Maintenance
Telligence
71PM000224A / 10 August 2022 / Ver. H
• Clorox, Germicidal Wipes, bleach
• Dispatch Disinfection Wipes with Bleach
• Ecolab Achtichlor Plus
• Ecolab Asepti-Wipe II (Product # 61027330)
• Ethanol 85%
• Medtrol Gluco-chlor bleach (Micro-cill bleach)
• Sani-Cloth AF and AF3
• Sani-Cloth Bleach (orange canister)
• Sani-Cloth HB (green canister)
• Sani-Cloth Plus (red canister)
• Staphine
• Virkon S
• 10% bleach/water solution
3. Ensure the patient station to be cleaned is idle (no light should be illuminated or flashing).
4. Press and hold the patient station’s Cancel button (or another module’s Cancel button, if
available) for 4 seconds until its LED flashes once, then release the button. The following
occurs:
• All LEDs on the patient station and any modules attached to it will fast flash to indicate it
is in Cleaning mode.
• After 15 seconds, the devices will automatically exit Cleaning mode and the LEDs will
stop flashing.
5. Gently wipe the surface of the station with the damp cloth.
6. Clean any associated cords using the damp cloth.
7. Use another soft, dry cloth to wipe the station surface dry.
Notes:
• Cleaning mode may not be configured for your facility. Check with your system
administrator before cleaning the device.
• Cleaning mode may be configured for more or less time at your facility. Check with your
system administrator.
• If you have not finished cleaning a device by the time the Cancel light stops flashing, put the
station into Cleaning mode again.
• We recommend microfiber cloth for cleaning Telligence stations.
• Do not use abrasive cleaning agents.
• Do not submerge any cords that may be present.
Cleaning Pillow Speakers and Handsets
Clean pillow speakers and handsets with an approved disinfectant. Do not submerge pillow
speakers!
To clean a pillow speaker:
1. Damped a soft microfiber cloth with an approved cleaning solution.
• Cidex
• Staphine
• 10% bleach/water solution
2. Gently wipe the surface of the pillow speaker and the cord with the dampened cloth.
3. Use another soft, dry cloth to wipe the pillow speaker surface dry. Do not leave any droplets
on the pillow speaker or cord.
To Next Page
Loading...