Room Devices
Telligence
64PM000224A / 10 August 2022 / Ver. H
Figure 66: Cardiac and Emergency Pull Switches
A Cardiac and Emergency pull switches have no audio capability and cannot be used for voice
communication unless it is paired with a nearby speech module.
To activate or cancel a cardiac/emergency call event:
1. Pull the Cardiac or Emergency switch to send a Code Blue (cardiac) or emergency call event
to staff consoles and annunciators. Pulling the switches causes the following to occur:
• Lights linked buttons illuminate to confirm call placement.
• The call assurance tone sounds at any associated module or Room Display.
• The event will display on the associated corridor and zone lights.
• The pull tones sound at staff consoles and annunciators and at stations where staff
follow is active.
• A call event appears on the Call screen on staff consoles, emergency annunciators and
unit annunciators.
2. To cancel the call, push the pull switch.
• Code button lights extinguish.
• Call lights extinguish on any associated Bedside module or staff device, if they are
linked.
• Dome lights extinguish.
• Tones stop at staff consoles, annunciators, and at stations where staff follow is active.
• The nurse call event is removed from staff consoles and annunciators.
The 37-Pin Bed Receptacle
The 37-Pin Bed Receptacle is a wall-mounted, 37-pin D-sub female connector attached to a
stainless steel plate. The receptacle supports electronic beds with side-rail communications.
To Next Page
Loading...