ASCOM Telligence

To Next Page

To Previous Page

Room Devices

Telligence

48PM000224A / 10 August 2022 / Ver. H

To attach a device to the SafeConnect socket:

1. Align the SafeConnect plug on the device cable with the SafeConnect socket.

2. Insert the plug into the socket until the socket’s magnet secures the plug.

To release a device from the SafeConnect socket:

 For handsets and pillow speakers, pull the plug from the sockets, and then press the button

showing a blinking LED, generally the Cancel or Presence button.

Note: If you unintentionally disconnect the cable, plug it back into the SafeConnect socket to

clear the cord fault event. The socket’s LED will stop flashing.

Set the Patient Station to Clear Call Events

When you plug a cable from a third-party device into a SafeConnect socket, you can then

choose how you want the Telligence system to clear event calls from that device. Choose

either Manual mode or Automatic mode.

Manual Mode

A manual clear requires a staff member to press the Cancel or Presence button on the Patient

Station when a call event is active. For example, pressing the button on a call cord activates an

event on the Patient Station. Pressing the Patient Station’s Cancel or Presence button clears

the event.

To set the Manual mode:

1. Insert the third-party device’s plug into a 3.5mm or ¼ inch adapter, and then connect the

adapter’s plug into the Patient Station's SafeConnect socket.

2. Check the LED above the SafeConnect socket. The LED will blink white for 3 seconds, and

then turn green. A green LED indicates that the Telligence system recognizes the external

device. If the LED does not turn green, then the Telligence system does not recognize the

device. Contact your system administrator for assistance.

Automatic Mode

An automatic clear occurs when the event call no longer needs action. For example, you may

want to use a bed pressure pad to alert you when a patient exits a bed. When the patient lays

on the bed and exerts pressure on the pad, the system is normal. However when a patient exits

the bed, the pressure is removed and the system triggers an event.

To set the Automatic mode:

1. Insert the external device’s plug into a 3.5mm or 1/4 inch adapter, and then connect the

adapter’s plug to the Patient Station's SafeConnect socket. The SafeConnect LED blinks

white for 3 seconds.

2. While the LED is blinking, press the Cancel or Presence button. The LED turns white. Event

calls will automatically clear when the external device returns to it normal state.

ASCOM Telligence - Page 54