ATV 200 - Page 202

5. Select Washer D
When replacing left crankcase forward gear,
reverse gear, rear cover and output shaft, washer
of output shaft needed to be adjusted.
1) Calculate the washer thickness of output shaft
by following formula
D
Washer thickness of output gear:
d + j - e - B-k-1-0.25
=
is the value engraved on left crankcase
is the value engraved on rear cover
is the bearing (at output gear) thickness
¡°13.00¡±
¡°k¡±is the value engraved on forward gear
¡°l¡±is the value engraved on output shaft
2) For example:
¡¤If¡°0.97¡±is engraved on rear cover
¡¤¡°110.05¡±is engraved on left crankcase
¡¤¡°14.4¡±is engraved on forward gear
¡¤¡°80.45¡±is engraved on output shaft
¡¤So the washer thickness is:
e
d
j
D
D
=110.05-0.97-13.00-0.50-14.4-80.45-
0.25=2.42mm
3) The following is the prepared washer
thickness(mm)
1.0
1.1
1.3
1.5
1.7
Washer selection table
The washer thickness is 2.42mm by calculation.
So the washer thickness should select 2.5mm
according to above table.
range of washer thickness
1.8 ¡ÜD ¡Ü1.9
1.9 £¼D ¡Ü2.0
2.0 £¼D ¡Ü2.1
2.1 £¼D ¡Ü2.2
2.2 £¼D ¡Ü2.3
2.3 £¼D ¡Ü2.4
2.4 £¼D ¡Ü2.5
2.5 £¼D ¡Ü2.6
2.6 £¼D ¡Ü2.7
2.7 £¼D ¡Ü2.8
2.8 £¼D ¡Ü2.9
2.9 £¼D ¡Ü3.0
selected washer
1.7
2.0
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
3.0
- 196 -