Audi Q7 2007 - Page 153

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of lubrication system
147
6
– Fit sump (top section) and tighten bolts -1 ... 4- in diagonal
sequence initially to 5 Nm.
– Tighten bolts -1 ... 4- in diagonal sequence.
Remaining installation steps are carried out in reverse se-
quence; note the following:
– Install oil pump ⇒ page 143.
– Install sump (bottom section) ⇒ page 141.
– Install sealing flange (front) ⇒ page 44.
– Install chain for oil pump and balance shaft ⇒ page 85
– Install timing chain covers ⇒ page 60.
– Bolt gearbox to engine ⇒ page 32.
– Fill up with engine oil and check oil level ⇒ page 157.
Tightening torques
Component Nm
Sump (top section) to cylinder block 14
Oil pipe to: Sump (top section) 9
Cylinder block 9
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259