To configure test calls:
1. Open the Test Call Table page (Configuration tab > System menu > Test Call >
Test Call Table).
2. Click the Add button; the following dialog box appears:
Figure 40-1: General Tab of Test Call Table
3. Configure the test endpoint parameters as desired. See the table below for a
description of these parameters.
4. Click Submit to apply your settings.
Table 40-1: Test Call Table Parameters
Parameter Description
General Tab
Endpoint URI
[Test_Call_EndpointURI]
Defines the endpoint's URI. This can be defined as a user or
user@host. The device identifies this endpoint only by the URI's
user part. The URI's host part is used in the SIP From header in
REGISTER requests.
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Called URI
[Test_Call_CalledURI]
Defines the destination (called) URI (user@host).
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
To Next Page
Loading...
