addresses are not configured in the routing table.
Web/EMS: Filter Calls to IP
[FilterCalls2IP]
Enables filtering of Tel-to-IP calls when a Proxy is used (i.e.,
IsProxyUsed parameter is set to 1 - see 'Configuring Proxy
and Registration Parameters' on page 184).
[0] Don't Filter = (Default) The device doesn't filter calls
when using a Proxy.
[1] Filter = Filtering is enabled.
When this parameter is enabled and a Proxy is used, the
device first checks the Tel to IP Routingbefore making a call
through the Proxy. If the number is not allowed (i.e., number
isn't listed in the table or a call restriction routing rule of IP
address 0.0.0.0 is applied), the call is released.
Note: When no Proxy is used, this parameter must be
disabled and filtering is according to the Tel to IP Routing.
Web: Add CIC
[AddCicAsPrefix]
Determines whether to add the Carrier Identification Code
(CIC) as a prefix to the destination phone number for IP-to-
Tel calls. When this parameter is enabled, the 'cic'
parameter in the incoming SIP INVITE can be used for IP-to-
Tel routing decisions. It routes the call to the appropriate
Hunt Group based on this parameter's value.
[0] No (default)
[1] Yes
For example, as a result of receiving the below INVITE, the
destination number after number manipulation is
cic+167895550001:
INVITE
sip:5550001;cic=+16789@172.18.202.60:5060;user=phone
SIP/2.0
Note: After the cic prefix is added, the IP to Hunt Group
Routing Table can be used to route this call to a specific
Hunt Group. The Destination Number IP to Tel Manipulation
table must be used to remove this prefix before placing the
call to the Tel.
Web: ENUM Resolution
CLI: enum-service-domain
[EnumService]
Determines the ENUM service for translating telephone
numbers to IP addresses (or domains). For example,
e164.arpa or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
ENUM-based routing is configured in the Tel to IP Routing
using the "ENUM" string value as the destination address.
To Next Page
Loading...
