 [1] Yes
For example: To route an incoming IP-to-Tel call with destination
number "21100", the IP to Hunt Group Routing Table is scanned
for a matching prefix. If such a prefix is found (e.g., "21"), then
before the call is routed to the corresponding Hunt Group, the
prefix "21" is removed from the original number, and therefore, only
"100" remains.
Notes:
 This parameter is applicable only if number manipulation is
performed after call routing for IP-to-Tel calls (i.e.,
RouteModeIP2Tel parameter is set to 0).
 Similar operation (of removing the prefix) is also achieved by
using the usual number manipulation rules.
[SwapTel2IPCalled&CallingNu
mbers]
Determines whether the device swaps the calling and called
numbers received from the Tel side (for Tel-to-IP calls). The SIP
INVITE message contains the swapped numbers.
 [0] = (Default) Disabled
 [1] = Swap calling and called numbers
Note: This parameter can also be configured in a Tel Profile.
Web: Add Number Plan and
Type to RPI Header
EMS: Add Ton 2 RPI
[AddTON2RPI]
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.
 [0] No
 [1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1)
and AddTON2RPI = 1, it's possible to configure the calling and
called number type and number plan using the Number
Manipulation tables for Tel-to-IP calls.
Web/EMS: Source Manipulation
Mode
[SourceManipulationMode]
Determines the SIP headers containing the source number after
manipulation:
 [0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.
 [1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
source number before manipulation.
Calling Name Manipulations IP-to-Tel Table
[CallingNameMapIp2Tel]
Configures rules for manipulating the calling name (caller ID) in the
received SIP message for IP-to-Tel calls. This can include
modifying or removing the calling name. The format of this table ini
file parameter is as follows:
[ CallingNameMapIp2Tel ]
FORMAT CallingNameMapIp2Tel_Index =
CallingNameMapIp2Tel_DestinationPrefix,
CallingNameMapIp2Tel_SourcePrefix,
CallingNameMapIp2Tel_CallingNamePrefix,
CallingNameMapIp2Tel_SourceAddress,
CallingNameMapIp2Tel_RemoveFromLeft,
CallingNameMapIp2Tel_RemoveFromRight,
CallingNameMapIp2Tel_LeaveFromRight,
CallingNameMapIp2Tel_Prefix2Add,
To Next Page
Loading...
Need help?
General
