2.
3.
Connect a PC to the controller and upload system data from the controller to the PC.
This makes it easy to set system data.
The Upload System Data button will retrieve settings and
controller information from the PPC5 controller. It is strongly
recommended that settings and controller information be
uploaded from the controller.
Set the controllers’s parameter PARA version.
Must be set to “DON’T USE”
Example
Set the controllers’s control mode (CTLM).
The Series Selection drop down box will be populated
automatically, with UT50A Series, after uploading system
data from the PPC5 controller. Optionally UT50A Series
can be manually selected in the drop down box.
Set the controllers’s input sampling period (control period).
Refer to Manual Setting Values Table below
The Standard Suffix Codes section will be
populated automatically after uploading
system data from the PPC5 controller.
Optionally to create a file without
uploading from a controller, fields must be
manually entered using the data from the
Manual Setting Values table provided
below before clicking the OK button.
Detailed Suffix Codes are not used with
the PPC5 controllers, and will not be
displayed after uploading settings from
the controller.
These fields are automatically
populated after uploading system
data from the controller.
The Parameter Version drop down box
will be populated automatically after
uploading system data from the PPC5
controller. When manually configuring the
default selection should be used.
Clicking the [Upload System Data] button enables the parameter setting software to
communicate with the controller to load system data into it.
To Next Page
Loading...
