Page | 76 of 105
AVR8414 Operation Manual – Rev O
Table 8 – Messages by Event
On-Screen Display
(OSD) Message
A queued record or reach-back request
cannot be started at this moment (for
example, time set is in progress, etc.) and
has been queued until conditions allow
RBK<#>/REC<#> START
QUEUED
RBK<#>/REC<#> START
KLV errors were detected in the KLV
capture, and recording of KLV has been
(ERRORS)
(ERRORS)
Cannot start playback. File selected for
playback is too short to play.
<STROAGE> IS TOO
Cannot start playback. There is not enough
system bandwidth.
DECODE ACTION
EXCEEDS BANDWIDTH
Cannot start playback. The pre-playback
parse process failed for the playback file.
FILE-NAME> FOR
Cannot start playback. A file is not selected.
NO FILE SELECTED FOR
PLAYBACK
Cannot start playback. Selected file for
playback does not exist.
<TS-FILE-NAME> ON SD
FILE DOES NOT EXIST
The record storage device is full, and the
record target has changed to the overflow
storage device.
TARGET CHANGED
FROM <STORAGE
DEVICE> TO <STORAGE
The record file size reached the maximum
file size limit (2GB), and recording started
to a new file on the same storage device.
TARGET FILE CHANGED
The format to FAT32 of a storage device
failed.
FORMAT OF <STORAGE
DEVICE> FAILED
FORMAT OF <STORAGE
DEVICE> FAILED
The system could not repair a storage
device. A typical reason why repair may be
required is a disk becoming read-only after
power was disrupted to the DVR while
DEVICE> FAILED
DEVICE> FAILED
Streaming two Ethernet UPD streams to
the same IP port is not allowed.
CANNOT HAVE
IDENTICAL IP PORT
Streaming two Ethernet UPD streams to
the same IP port is not allowed.
THE SAME IP PORT AS
To Next Page
Loading...
Need help?
General