Page | 77 of 105
AVR8414 Operation Manual – Rev O
Table 8 – Messages by Event
On-Screen Display
(OSD) Message
An attempt to export a log has failed.
EXPORT FAIL – TARGET:
EXPORT FAIL
A log or DVR settings was successfully
exported.
<EXPORT TYPE>
EXPORT DONE
<EXPORT TYPE>
EXPORT DONE
The software update failed because there
was not enough room.
SW UPDATE FAILED.
ERROR: REPO TO FULL
The software update failed because no
software package was found on the
<STORAGE DEVICE>
<STORAGE DEVICE>
The software update failed because
software package could not be copied.
ERROR: GET PACKAGE
The software update failed because
software package md5 checksum does not
match the calculated md5 checksum.
ERROR: md5cmd
The software update failed because
software package could not be unpacked.
SW UPDATE FAILED.
ERROR: UNPACK
The CODEC capture needs to be
reconfigured to allow pass-through of
selected channel. Capture cannot be
reconfigured if the CODEC is already in use
for recording or reach-back or playback.
STOP REC<#> AND TRY
AGAIN
Configuration import failed because the
new configuration could not be unpacked.
LOAD FAILED. ERROR:
UNPACK
Configuration import failed because the
new configuration file does not exists.
LOAD FAILED. ERROR:
UNPACK NO FILE
Configuration import failed because the
new configuration file is empty (size is
UNPACK EMPTY
Configuration import failed because the
configuration file copy to system failed.
Configuration import failed because play or
record is active.
CANNOT UPDATE
CONFIG WHILE PLAY
Configuration import failed because reach-
back is active.
CANNOT UPDATE
CONFIG WHILE PLAY
OR REACHBACK IS
Configuration import failed because the
configuration source storage device was
<STORAGE DEVICE>
To Next Page
Loading...
Need help?
General