SYSTEM CONFIGURATION Chapter 8
8 - 7
CAUTION
To prevent corruption of the configuration data, do not turn off the
pump while UPDATING is being displayed.
8.4.1.2.4 MODIFY LIBRARY
The MODIFY LIBRARY function allows the operator to rename, enable or disable a
protocol library.
Immediately after the MODIFY LIBRARY function is selected, the pump displays ENABLE
NONE LIBRARY OPTION with a Y or N response, indicating respectively that the option is
currently enabled or disabled. Enabling this option adds a NONE selection to the list of
available libraries, allowing protocol selection to be bypassed during normal programming.
Press ▲ or ▼ if necessary to change the response and press CONFIRM to complete this
step.
At the ▲ ▼ SELECT LIBRARY prompt, press ▲ or ▼ as necessary to select the library to
be modified, and press CONFIRM to complete the selection.
Once a library has been selected, the pump displays NAME <library-name> where <library-
name> is the name of the selected library. Press CONFIRM to accept the current library
name, or change the name to any name that is not already assigned to another library.
Press CONFIRM to complete the library name entry.
Next, the pump displays ENABLE NONE PROTOCOL OPTION with a Y or N response,
indicating respectively that the option is currently enabled or disabled. Enabling this option
adds a NONE selection to the list of available protocols in the library, allowing protocol
selection to be bypassed during normal programming. Press ▲ or ▼ if necessary to
change the response and press CONFIRM to complete this step.
Next, the pump displays ENABLE <library name> with a Y or N response, indicating
respectively that library is currently enabled or disabled. Only the names of enabled
libraries are displayed at the SELECT LIBRARY programming step. Press ▲ or ▼ as
necessary to change the response and press CONFIRM to complete this step. The pump
displays UPDATING.
CAUTION
To prevent corruption of the configuration data, do not turn off the
pump while UPDATING is being displayed.
To Next Page
Loading...
Need help?
General
