Graphical Caregiver Interface (GCI) Controls
54 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
Verify the Patient Identity when Zeroing the Scale
When Bedside Association is On, and you zero the scale for a new patient, you will be asked to verify the
bed location and, if applicable, patient identity.
• If you are verifying the bed location and patient
identity, the Patient Identity screen will show. You
have these options:
– Ye s —press this control if the patient identity
shown is correct. The zeroing process will
continue.
– No—press this control if the patient identity
shown is not correct. You will be directed to
contact the unit coordinator / charge nurse.
From that screen, you can continue with the
zeroing process.
– Cancel—press this control if you do not want to verify the patient identity. The zeroing
process will continue.
At the end of the zeroing process, you will see one of these screens as applicable:
New Patient Assignment and Bedside Association
When a new patient is assigned to the bed through the
ADT system, this screen will show and stay on the screen
until the question is answered, and a repeating tone will
sound. You have these options:
• Continue—press this control if the room number
shown on the screen is correct and you want to
verify the patient. See “Verify the Patient Identity”
on page 53.
• Cancel—press this control if you do not want to verify the patient. The Home screen will show.
• Change Room—press this control to associate a different room to the bed. The bed will
retrieve room data, and then the Building screen will show. Select the Building, Floor, and
Room number.
To Next Page
Loading...
