Surfaces
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 83
Patient Comfort
Sleep Mode
To Deactivate
1. Press the Surface menu control on the GCI screen.
2. Press Normal.
Allows customizing based on patient request while maintaining pressure redistribution.
The system automatically supplies pressure distribution for the patient’s position on the surface.
To Adjust the Firmness
1. Press the Surface menu control on the GCI screen.
2. Press Patient Comfort.
3. Use the Patient Comfort controls to change the
pressure in the head, seat, and lower leg sections of the
mattress assembly:
•To Increase the pressure, press the Up arrow.
•To Decrease the pressure, press the Down arrow.
To Deactivate
1. Press the Surface menu control on the GCI screen.
2. Press Normal.
The Sleep Mode is available on some bed models. The Sleep Mode is used to reduce frequency of air
system adjustments for patients who are sensitive to air surface movements. Pressure redistribution is
active during Sleep mode. The air pressure in the surface is monitored, but the air pump does not run
unless the air pressure falls below or raises above a preset level.
After eight hours, the Normal mode reactivates.
To Next Page
Loading...
Need help?
General
