pro+ Surface Instruction for Use (209196 REV 8) 99
Specifications
Classification and Standards
Flammability Codes—United States and Canada
All pro+ surfaces meet the applicable United States and Canadian
flammability specifications.
Electromagnetic Emissions Guidance
Caution—This device meets all requirements for electromagnetic
compatibility per IEC 60601-1-2. It is unlikely that the user will encounter
problems with this device because of inadequate electromagnetic
immunity. However, electromagnetic immunity is always relative, and
standards are based on anticipated environments of use. If the user
observes unusual device behavior, particularly if such behavior is
intermittent and associated with nearby use of radio or TV transmitters,
cell phones, or electro-surgical equipment, this could be an indication of
electromagnetic interference. If such behavior occurs, the user should try
to move the interfering equipment further from this device.
To help prevent injury and/or equipment damage, obey these warnings:
• Warning—The pro+ surface should not be used adjacent to or
stacked with other electrical equipment. If adjacent or stacked
use is necessary, observe the pro+ surface and the other
electrical equipment to make sure they operate as intended.
Classification Standard
Technical and quality
assurance standards
AAMI ES 60601-1
IEC 60601-1
IEC 60601-1-8
ISO 10993-1
ISO10993-5
ISO 10993-10
CAN/CSA-C2.22 No. 60601-1
Degree of protection
against electric shock
IPX4
To Next Page
Loading...
