100 pro+ Surface Instruction for Use (209196 REV 8)
Specifications
(Warnings continued) To help prevent injury and/or equipment damage,
obey these warnings:
• Warning—Make sure the pro+ surface operates correctly when
it is used near other electronic devices. Portable and mobile radio
frequency (RF) communications equipment can affect electrical
equipment.
• Warning—Use of accessories, transducers and cables other than
those specified or provided by the manufacturer of this
equipment could result in increased electromagnetic emissions
or decreased electromagnetic immunity of this equipment and
result in improper operation.
Medical equipment needs special precautions in regard to
electromagnetic compatibility (EMC) and needs to be installed and put
into service according to the EMC information supplied in the tables that
follow.
Guidance and Manufacturer's Declaration -
Electromagnetic Immunity
The pro+ surface is intended for use in the electromagnetic environment specified below.
The customer or the user of the pro+ surface should make sure it is used in such an
environment.
Emissions Test Compliance Electromagnetic Environment —Guidance
RF Emissions
CISPR 11
Group 1 The pro+ surface uses RF energy only for its
internal functions. Therefore, its RF emissions are
low and are not likely to cause any interference
in nearby electronic equipment.
RF Emissions
CISPR 11
Class A The pro+ surface is suitable for use in all
establishments other than domestic
establishments, and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage
Fluctuations/
Flicker Emissions
IEC 61000-3-3
Complies
NOTE: The Emissions characteristics of this equipment make it suitable for use in industrial
areas and hospitals (CISPR 11 class A). If it is used in a residential environment (for which
CISPR 11 class B is normally required) this equipment might not offer adequate protection
to radio-frequency communication services. The user might need to take mitigation
measures, such as relocating or re-orienting the equipment
To Next Page
Loading...
