74 | Chapter 3: Operation
l Well A1 is opposite the
chamfered or beveled
edges.
l The plate is labeled with the
washer's serial number.
l When the plate is on the
carrier in the proper
orientation, the "Front"
label is visible.
Verify Test Plate
Important guidelines:
l Always put the plate on the carrier with well A1 in the
back, left corner of the carrier.
l Clean the plate after each use if you are using wash
buffer to run the test.
l Fully dry the plate after each use and before putting it
back in its foam-lined box.
l Inspect the plate regularly for damage, e.g.
scratches, chips, warping.
l Replace the plate when it is damaged. See
Replacement Procedure for Verify Test Plate
on page 134 in the operator's manual.
405™ Microplate Washer LS
To Next Page
Loading...
