12
Use your tablet or your PC to quickly access detailed and comprehensive information on all our products on www.blemo.com .
The internet site provides the information you need for products and solutions
Terminology
The technical terms, terminology, and the corresponding descriptions in this manual normally use the terms
or definitions in the relevant standards.
In the area of drive systems this includes, but is not limited to, terms such as error, error message, failure,
fault, fault reset, protection, safe state, safety function, warning, warning message, and so on.
Among others, these standards include:
•
IEC 61800 series: Adjustable speed electrical power drive systems
•
IEC 61508 Ed.2 series: Functional safety of electrical/electronic/programmable electronic safety-related
•
EN 954-1 Safety of machinery - Safety related parts of control systems
•
EN ISO 13849-1 & 2 Safety of machinery - Safety related parts of control systems.
•
IEC 61158 series: Industrial communication networks - Fieldbus specifications
•
IEC 61784 series: Industrial communication networks - Profiles
•
IEC 60204-1: Safety of machinery - Electrical equipment of machines - Part 1: General requirements
In addition, the term zone of operation is used in conjunction with the description of specific hazards, and is
defined as it is for a hazard zone or danger zone in the EC Machinery Directive (2006/42/EC) and in ISO
12100-1.
Also see the glossary at the end of this manual.
To Next Page
Loading...
