Programming
What's in this Part?
This part contains the following chapters:
Chapte r Chapte r Nam e
Page
4
Reference Mode (rEF) 43
5
Monitoring Mode (MOn) 47
6
Configuration Mode (ConF) 77
7
Interface (ItF) 279
8
Open / Save as (trA) 295
9
Passw ord (COd) 299
10 Multipoint Screen 301
Incorrect wiring, uns uitable settings or uns uitable data m ay trigger unanticipated m ovem ents, trigger s ignals
or dam age parts and disable m onitoring functions.
If the power s tage is disabled unintentionally, for exam ple as a res ult of power outage, errors or functions, the
m otor is no longer decelerated in a controlled way.
WARNING
MOVEMENT WITHOUT BRAKING EFFECT
Verify that movements without braking effect cannot cause injuries or equipment damage
Failure to follow these instructions can result in death, serious injury, or equipment damage.
WARNING
UNANTICIPATED EQUIPMENT OPERATION
Do not operate the drive system with unknown settings or data.
Never modify a parameter unless you fully understand the parameter and all effects of the modification.
When commissioning the product, carefully run tests for all operating states and potential error situations.
Verify that a functioning emergency stop push-button is within reach of all persons involved in running
tests.
Verify the functions after replacing the product and also after making changes to the settings or data.
Anticipate movements in unintended directions or oscillation of the motor.
Only operate the system if there are no persons or obstructions in the zone of operation.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
II
To Next Page
Loading...
