Maintenance
Limitation of Warranty
The warranty does not apply if the product has been opened, except by BLEMO services .
Servicing
It is recom m ended to do the following in order to optim ize continuity of operation.
Environm ent Part conce rned Action Periodicity
Knock on the product
Housing - control block
(led - display)
Check the drive visual aspect
At least each year
Corrosion Terminals - connector - screws -
EMC plate
Inspect and clean if required
Dust Terminals - fans - blow holes
Temperature Around the product Check and correct if required
Cooling Fan Check the fan operation
Replace the fan After 3 to 5 years, depending
on the operating conditions
Vibration Terminal connections Check tightening at recom-
mended torque
At least each year
Note:
The fan operation depends on the drive thermal state. The drive may be running and the fan not.
Spares and repairs
Serviceable product. Pleas e refer to your Cus tom er Care Centre.
Long time storage
If the drive was not connected to m ains for an extended period of tim e, the capacitors m ust be restored to their
full perform ance before the m otor is s tarted. See page 39.
Fan replacement
It is pos sible to order a new fan for the ER24 m aintenance, see the com m ercial references on
www.blem o.com.
Fans m ay continue to run for a certain period of tim e even after power to the product has been dis connected.
CAUTION
RUNNING FANS
Verify that fans have come to a complete standstill before handling them.
Failure to follow these instructions can result in equipment damage.
CAUTION
RISK OF DAMAGE TO THE DRIVE
Adapt the following recommendations according to the environment conditions: temperature, chemical, dust.
Failure to follow these instructions can result in equipment damage.
10
To Next Page
Loading...
