Configuration Mode (ConF)
Torque
limitation via
parameter
Low est value
taken into account
value
TORQUE LIMITATION
There are two types of torque lim itation:
•
With a value that is fixed by a param eter
•
With a value that is set by an analog input (AI or pulse)
If both types are enabled, the lowes t value is taken into account. The two types of lim itation can be configured
or s witched rem otely us ing a logic input or via the com m unication bus.
[Torqu
e
limit. activ.]
(
tL
A
)
[M otoring torque
lim]
(
tL
IM
)
[Gen. torque lim]
(
t
LIG
)
[Torque ref. assign.]
(
tAA
)
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FUN- > TOL-
[AI.]
(
AI
.)
Torque
limitation via
RP
[RP]
(
PI
)
To Next Page
