Steps for setting-up the drive
INSTALLATION
1.
Please refer to the installation manual.
PROGRAMMING
2.
Apply input power to the drive, but do not give a run
command.
Tips:
•
Before beginning programming, com plete the customer
setting tables , page 321.
•
Us e the
[Restore config.]
(FCS) param eter, page 81, to
return to the factory s ettings at any tim e.
•
To locate the des cription of a function quickly, us e the index
of functions page 319.
•
Before configuring a function, read carefully the "Function
com patibility" s ection page 165.
Note
: The following operations m ust be perform ed for
optim um drive perform ance in term s of accuracy and
res pons e tim e:
•
Enter the values indicated on the m otor rating plate in the
[MOTOR CONTROL]
(drC-)
m enu, page 105.
•
Perform auto-tuning with the m otor cold and connected
using the
[Auto-tuning]
(tUn)
param eter, page 87.
3.
Configure:
•
The nom inal frequency of the m otor
[Stand
ard
m
ot. f
re
q]
(
bF
r
) page 86 if this is not 50 Hz.
•
The m otor param eters in the
[MOTOR CONTROL]
(drC-)
m enu, page 105, only if the factory configuration of the drive is
not s uitable.
•
The application functions in the
[I
NPUTS
/ OUTP
U
TS
C
FG
]
(
I_
O-
) menu, page 125, the
[COMMAND]
(CtL-)
m enu, page 154, and the
[APPLICATION FUNCT.]
(FUn-)
m enu, page 167, only if the
factory configuration of the drive is not s uitable.
4. In
the
[SETTING S]
(
SE
t-
)
menu,
adjust
the following parameters:
•
[Acceleration]
(ACC), page 87 and
[Deceleration]
(dEC), page 87.
•
[Low speed]
(LSP), page 87 and
[High speed]
(HSP), page 89.
•
[Mot. therm. current]
(
It
H
), page 87.
5.
Start the drive.
To Next Page
Loading...
